GR7091-23

The Omnibus F4 Pro V4 Corner flight controller uses the ICM20608 over SPI for the best possible flight performance. With onboard damping box， the ICM20608 runs perfect under 32k Gyro loop. If you haven't already seen it， you should check out Josh's awesome video on different IMUs. Also onboard are a barometer and AT7456 OSD chip for the BetaFlight integrated OSD.
Omnibus F4 Pro Corner supports 3-6s LIPO direct input， build in Current Sensor and Power Filter too.

最新版本Omnibus F4 PRO V4 穿越機飛控 自帶減震IMU，升級到ICM20608加速度計可以運行32k gyro loop ，板載IMU減震模組最大限度降低震動，帶來更加出色的飛行體驗。

Features:
　• STM32 F405 MCU， Runs Betaflight firmware(supported from v3.2)
　• ICM20608 Over SPI Bus in damping box.
　• 30.5x30.5mm Mounting holes
　• Supports Lipo direct plug in (3-6S)
　• Suports 5V 1A BEC output(Buck)
　• STM32 controls OSD chip over SPI in DMA mode(Betaflight OSD)
　• Build in Current sensor
　• Build in Professional level PDB
　• Build in LC filter for Camera power(max 800ma)